Pond vacuum with collecting container

These models differ in the volume of the collection container and the connected value. The sludge is sucked through a hose and is collected in the container. Since most pond cleaners have a small volume, the container is quickly full and needs to be cleaned.  This is like the vacuum cleaner bag or the catcher at Lawn mower, Since the container must be cleaned frequently, no continuous work is possible. For smaller garden ponds that is not a problem even with the pool cleaning. Larger ponds require a maximum amount of work.  

• Water is sucked in
• Mud and filth settle on the ground
• If the container is full, the pond vacuum will shut off 
• The sludge must be removed manually from the container
• the clean water can go back to the pond 
• especially suitable for swimming pool or very small ponds

Some models filter the dirt so that the extracted water can flow back into the garden pond. These models have a drain hose.

Pond vacuum with 2 chambers

The pond sump 2 chamber system works with two separate, internal containers. While the sludge is being absorbed, the other container may empty. The collected sludge is pumped out via a drain hose at the same time. There is no manual emptying necessary, the system works fully automatically. Such a system is the non-plus ultra for a deeper or larger garden pond. 

• Water is sucked in
• Mud and debris settle in a separate container
• the water flows back into the pond via the other chamber 
• fully automatic emptying of the sludge via a drain hose
• Sucking without interruption 
• especially suitable for larger ponds 

A key purchase criterion is the performance, which is indicated by the electrical power in watts. You can clean a small pond with about 20 m³ content with almost any pond vacuum cleaner. This also applies to most pools. Here is enough power under 1.500 watts. The bigger the pond, the stronger the motor power should be, ideally over 2.000 Watts. 

The capacity has nothing to do with the performance in watts. It should actually be referred to as suction, because it is composed of the suction force (negative pressure) and the flow rate. The delivery rate indicates how much water can be pumped per hour.

A model with sludge catcher is cheaper in price like a two-chamber system. However, if the container is full, it must be emptied, which is always associated with standstill. The container must be removed and cleaned.

In a model with 2 chamber system two chambers are alternately filled and emptied. The pond sludge is emptied via a drain hose and the purified water is automatically returned to the pond. 

The suction height is needed for the pond depth and how long the suction hose or the suction pipe must be.  The suction pipe should in any case reach to the bottom of the pond. Also, its diameter should not be less than 4 to 5 centimeters to prevent rapid clogging. 

The suction hose determines the water depth from which you can suck mud or other contaminants. The longer it is, the deeper you can work in the water. Particularly comfortable are transparent suction hoses or pipes. Here you can see immediately what is sucked through the hose.

For most of the 2 chamber models, we have found 2 meter length drain hoses. A longer hose may allow the sludge to be disposed of immediately on the compost. 

An good pond sludge sucker should be different  Suction nozzles have, so you get into every nook and cranny. If the pond bottom consists of different materials, such as pebbles or sand, you will need different nozzles. A bottom suction nozzle, on the other hand, absorbs algae upholstery.

If you want to run your pond sludge self-contained, you should already be careful that it is not too loud and may disturb neighbors. You can do this with the Pond mud sucker experiences other users, which is best read on the customer reviews on the Internet. 

Again, a long supply line is very beneficial, so your pond pump can be connected to the nearest outlet.

Where can I borrow pond sludge sucker?

If you are not sure yet which model you should buy, you can also get one Rent pond sludge sucker, Ask at your hardware store for equipment rental. Since not every construction or specialty store is doing that, you should be on the Internet to know who gives such a device.

How often do pond sucker use?

The frequency is always related to the pollution of the pond. At least a thorough cleaning should be done in the spring. If the water smells rotten, the pond vacuum should also be used. Further cleaning in autumn is recommended. 

Water is tipped - what to do?

Here only the complete refilling of the pond helps. You can prevent this only by the regular use of the Teichschlammsaugers.

How to deal with large pollution?

It is best to clean your garden pond in advance with a landing net and remove any floating debris. Beware of the deposited layers, they swirl quickly and the cleaning process takes more time. 

How to replace the missing water in the pond?

It is best to return the purified water back to the pond. If it is still necessary to refill with water, do not use tap water if possible. It is better to use rainwater, as tap water is very rich in nutrients and can stimulate algae growth.

Why is the suction power reduced?

This can happen if your pond vacuum cleaner draws false air. Check the seals of your device and possibly renew them.

A loss of suction power can also come about by exceeding the maximum suction height to conditions that builds the pond vacuum cleaner less negative pressure.